In an effort to help extend the life of the Bandolero engine, the US Legends Engine Shop has developed a carburetor spacer to help prevent the engine from "leaning out". This aluminum spacer will be used on engines that are not required to use restrictor plates.

This aluminum spacer will replace the original plastic spacer under the carburetor.

This spacer is currently available and will be allowed to be used at the Winter Heat races at Charlotte Motor Speedway. This aluminum spacer will be mandatory for use on all un-restricted Bandolero engines during the Winter National races at Citrus County Speedway 2/10/2020 through 2/14/2020.

The aluminum spacer is marked "INEX" & must remain stock as delivered by US Legend Cars International. It must be used with one un-cut gasket between the intake tube & the spacer and one un-cut gasket between the spacer & the carburetor. When using this spacer, it is recommended to use 112 (rear) & 107.5 (front/firewall) jets with the "small fan" engine or 110 (rear) & 105 (front/firewall) jets with the "big fan" engine.

Questions about installation, Please contact Jay Johnson @ (704) 455-3896.

 

Thank you for your cooperation.

INEX